SUZUKI CAPPUCCINO STRETCH DRIVESHAFT CV BOOT KIT - 96

REPLACE  BOOT WITHOUT THE NEED TO DISMANTLE THE JOINT AND SHAFT

SUPPLIED WITH MANUFACTURERS 2 YEAR GUARANTEE

HAS THE LOOK AND FEEL OF ORIGINAL EQUIPMENT

HIGH SPEC NEOPRENE - RESISTANT TO GREASE, OIL, ABRASION AND EXTREME TEMPERATURES

THE KIT CONTAINS:

INSTRUCTIONS

1 X INNER OR OUTER CV BOOT (OUTER ONLY)

2 X STAINLESS STEEL FIXING STRAPS

1 X 60G GREASE SACHET

Jack up the vehicle, remove the road wheel and hub.  Remove the old boot and clips.

Clean away any grease or debris from the shaft and joint.

Check fitting cone for sharp or rough areas.  Smooth with abrasive paper if necessary.

Spray out with silicone spray, apply grease or any lubricant to ease the boot on.

If fitting the new boot to an outer cv joint, turn the boot inside out.

Spray inside of boot with spray or use lubricant.

Place the large end over the narrow end of the cone.

Place the large end of cone over the joint.

Push the boot until it is clear of the cone.

Remove the cone and turn the boot right side out, if necessary.

Snip the corner of the grease sachet and fill the joint.

Slide and stretch the boot into position over the joint.

Secure the boot with fixing clips, removing any excess with tin snips.  Replace the hub and road wheel.

Or if preferred, the boot can be used as a standard universal boot if the stretch method is not used.

Please note we do not despatch on weekends, so deliveries for orders given over the weekend will be sent on Monday.