Honda CBR900RR 00-03 Gold X Ring Chain and Sprocket Kit

If you still have reservations for the correct motorcycle chain and sprocket fitment, our staff will be more than willing to guide you.

_____________________________________

Replacing the drive chain
There is a natural stretching of the drive chain to wear. The amount of stretch of a non sealed chain should not exceed 2.5% to 3% of the original chain length. Sealed chain stretch should not exceed 1% of its original length e.g.: 3/4" on a 110 link chain based on a chain with 5/8" pitch. Over these, the chain must be replaced along with the worn sprockets.

Lubrication
Motorcycle drive chains are exposed to dust, dirt, grime and other types of corrosive and erosive particles that can reduce their power transmission efficiency by more than 15% of their life to 1/100th of the chains that are correctly lubricated. In addition, regular lubrication puts a layer of oil between the roller and bushing to absorb the shock load.

Tension Adjustment
A drive chain that is too tight speeds up the wear by excessive pressure on the sprocket teeth, the chain joints and the gearbox main shaft bearings. A chain that is too loose will wear quickly and may have a whip action that can cause it to snap. A chain that is too tight or too loose will result in excessive elongation. Normal sag is about 3/4"

Sprocket Alignment
It is important to check sprockets periodically for wear. If wear occurs on one side of the sprocket teeth, it means there is misalignment, a condition which will result in a greatly reduced chain life. Check sprocket alignment visually by sighting across from the rear of the motorcycle or by placing a ruler or suitable straight edge against them to see if they are in the same place. Realign or replace as required

Maintenance of sealed Sprockets
External lubrication is recommended every 300 miles. Use paraffin oil for washing chains and NEVER use steam, thinners or solvent based products such as petrol and benzine. The amount of stretch should not exceed the points made in item 1. Where even one chain seal ring is missing or damaged the chain should be replaced. When replacing a chain we recommend it should be fitted endless as this is the only way the original chain strength can be maintained to 100%. On certain types of super bikes, this chain fitment is an absolute must.

When to replace
Bruises, rust, stiffness and damaged rings may all cause the chain to break. When finding any of these, it is recommended to replace the chain. It is also good practice to replace the sprockets when replacing the chain. If acid leaks from your battery onto the chain, it is recommended the chain is replaced as the acid will slowly reduce the strength of the chain

__________________________________________________________________________

Sellers: Get your own map today. Click here now. Simple."