BUY 4 HOLTS "TYRE WELD" SPARE WHEEL IN A CAN 400ML

DIRECTIONS FOR USE:

1. Remove object causing puncture and position puncture at the base of the wheel. Deflate tyre completely. Shake can vigorously. If cold, warm can in your hands or in hot air from the car heater vent.

2. Clean tyre valve thread and screw connection tube to it firmly so that the valve is in the 10 to 2 position if possible. Break the safety seal.

3. Holding the aerosol vertically in one hand turn the knob ¼ of a turn (in the ON direction) to the automatic transfer of the product. Allow the aerosol to EMPTY COMPLETELY and wash off excess immediately.

If you need to stop the automatic transfer whilst in use, turn the knob ¼ turn in the opposite direction (in the OFF direction). Once the aerosol is completely empty and the tyre re-inflated,turn ¼ turn (in the Off direction) BEFORE unscrewing the connector and replacing the valve cap.

IMPORTANT: immediately DRIVE FOR 6 TO 12 MILES (10 TO 20 KM). So that the product can be distributed uniformly and the gas pressure slackens off. Stop at the nearest service station to adjust the tyre pressure (in accordance with the manufacturer's instruction). Take your vehicle to a tyre repairer for repair or replacement of the affected tyre as soon as possible.

DO NOT REPAIR TYRES THAT HAVE COME OFF THE RIM, THAT ARE RIPPED, HAVE PUNCTURES LARGER THAN 5MM OR HAVE PUNCTURED WALLS.

CAUTION: Before work begins inform your tyre repairer that you have used Tyreweld.

Please note: Tyre repairers may add a small surcharge , due to the additional time