SPARE 8mm/16mm 
Projector Lamp Connector

If you have any questions, please feel free to email us at enquiries@esphotographics.com

Take a look in our shop, you might just find what you are looking for.

Many Belts for Projectors Inside.

Will Fit The Following Double Pin Type Lamps (pin gap 6mm)

12volt/100watt Reflector Lamp (A1/231) Majority of  8mm Projectors
12volt/100watt Capsule Lamp (M250 GX5.3) Eumig Mark S & others
15volt/150watt Reflector Lamp (A1/232) Elmo ST1200, Sankyo 800 Stereo & others
24volt/250watt Capsule Lamp (A1/223) Rank Aldis 16mm & others
24volt/200watt Reflector Lamp (A1/252) Earlier Elf 16mm Projectors
24volt/250watt Reflector Lamp (A1/259) Elf and Some Bell & Howell 16mm Projectors

May also be used if you are wanting to convert an old projector to a modern lamp type.

Does your projector lamp flicker on and off occasionally?
Or perhaps you've fitted a new lamp that still refuses to light?
Usually this is down to corroded contacts within the original lampholder caused by high current 
(8 amps for a 12v 100w lamp and around 10.5 amps for a 24v 250w lamp). 

This in turn will shorten the life of a new lamp significantly, which is definately not cost effective.
These new porcelain holders have a better sprung contact system inside that permits a more stable 
current transfer to the lamp. The cables are protected by heat resistant rubber and as a final 
protection, encased in a further heat/flame retardant shroud. 

This item needs to be soldered to the original wiring to your existing lamp.

Lamp not included and is for illustration only.