3m cable for Bang & Olufsen B&O Beolab Powerlink Mark 2

Studio-Quality Audio Cables for Bang and Olufsen Systems

This listing is for a high quality audiophile cable to allow you to connect Beolab active loudspeakers (all models, either with or without displays) to your Bang and Olufsen hifi system or television. The cable in this listing is three metres long. This cable will fit almost all B&O audio systems and TV’s manufactured since 1990 (ie. those with Powerlink output sockets) – if you are in any doubt, please ask!

High quality, shielded plugs with metal inner cases are used on our cables in preference to the cheap plastic plugs that you will see on many other companies’ cables. Our shielded plugs give better protection against induced electrical noise, which can degrade the sound quality produced. They are also far more rugged, to give you years of listening pleasure.  The cable is normally supplied in black (with black plugs), but you can request this in white (with grey plugs) at no extra cost.  Please remember that a black cable will be supplied unless you specifically request a white cable!

This cable is suitable for all of the current range of Bang and Olufsen Beolab active loudspeakers and most past models, including:-

• Beolab 1

• Beolab 2

• Beolab 3

• Beolab 4

• Beolab 5

• Beolab 7.1

• Beolab 7.2

• Beolab 9

• Beolab 10

• Beolab Penta

• Beolab 2500

• Beolab 3000

• Beolab 4000

• Beolab 4500

• Beolab 5000

• Beolab 6000

• Beolab 8000

It can also be used with older Beolab speakers that have displays (such as Beolab 3000, 3500, 4500, 5000 and Penta).

Cable specifications:-

• 3 metre long Multiple Screened High-Purity Copper cable with choice of either Black or White sheath

• Audio and Signal conductors: 7 x 0.1mm stranded copper

• Audio Screening conductor: 72 x 0.1mm stranded copper

• Data Screening conductor: 25 x 0.1mm stranded copper

• Black plastic cased 8-pin DIN plugs with metal inner case on black cables, or grey plugs on white cables

• Overall Cable Diameter: 4mm

• "Data", “Speaker On” and “Voltage Reference” signal wires connected for use with all Beolab loudspeakers

Please note: Very few other companies' cables use shielded cable and plugs. Even fewer use high-purity, stranded copper for optimum signal quality. If other companies' listings don't state these specifications, then their cables usually don't come anywhere near our quality! If you've invested in a good quality audio system, then you need good cables to get the best from it. All of our cables are designed and tested by a Graduate Electronics Engineer with over 20 years experience of B&O equipment.

Worldwide Priority Shipping is FREE for all of our cables!

Or you can collect in person from our Leicestershire workshop if you prefer.

Please note that we are currently unable to accept payments from, or ship items to, either Nigeria or Antarctica. We trust that this will not inconvenience too many of our customers!