2 PCS MRF MASTER + FREE OILING + TOE - CRICKET BATS**

ALL new bats require knocking in after they have been oiled, this is best performed with a special knocking in mallet. Start by gently knocking and deflecting the mallet against the blade paying special attention to the edges and toe area of the bat. Always knock in from the front face of the bat, NEVER from the sides or underneath the toe. Gradually increase the force of the blows over a period of time until you are comparable with the force of a ball used in match conditions. The initial knocking in stages should take at least 6 full hours of blows, remember to pay most attention to the edges (outermost 1" of wood) and the front of the toe area.

After these six hours use your bat with soft, old balls in the nets, then examine the face for seam marks. If deep seam marks are present your bat requires some more knocking in. Knock in for a further one hour and repeat the gentle net session. During these initial net sessions be careful and do not attempt extravagant cross bat shots and slogs, you are still testing your bat and damage could result if the bat is under prepared. Once no further deep seam marks appear your bat is ready for testing against newer, harder balls, repeat the process until no deep seam marks appear with new balls. At this point your bat should be ready for match use. WE STRONGLY ADVISE FITTING A TOE GUARD TO YOUR BAT, THEY PROTECT AGAINST SO MUCH POTENTIAL DAMAGE TO THE VULNERABLE TOE AREA.

As a precaution you might want to apply a toe guard and / or an Anti-scuff face to your new bat. A toe guard is a good idea as it will help to prevent toe damage and also stop water ingression and reduce friction damage when used on indoor surfaces or hard pitches. A clear anti-scuff face will help prevent damage to the face and slow the process of natural cracking of the willow. We don't want to force these extra expenses on people (please note: we have kept our prices to a minimum on these protective items) but they really will extend the life of your bat without compromising on performance, they are also best used on a new bat as a preventative measure rather than as a repair when the damage will already have been done. WE STRONGLY ADVISE FITTING A TOE GUARD TO YOUR BAT, THEY PROTECT AGAINST SO MUCH POTENTIAL DAMAGE TO THE VULNERABLE TOE AREA.

Please remember willow is a soft fibrous wood, which makes it ideal for cricket bats, but it will crack. The grains will naturally open slightly over time and with use. This is superficial and is indicative of the willow settling down too its job of work. Other cracks and indents will also occur, especially with miss-timed shots, edges and hits on the toe. Cricket bats are designed to hit the ball 12-20 cm up from the toe and in the middle of the blade, failure to do this could result in damage to the bat which is not the result of a fault in the bat, damage to the edges and toes caused by mis-hits is not covered by any bat warranty from any manufacturer or supplier.