1mW Green Laser Light Sky Pointer Pen 532nm High Power

Little bit about our Green Laser Pointer:

Green laser pointers appeared on the market circa 2000, and are the most common type of DPSS lasers (also called DPSSFD, diode pumped solid state frequency-doubled). They are much more complicated than standard red laser pointers, because laser diodes are not commonly available in this wavelength range. The green light is generated in an indirect process, beginning with a high-power (typically 100-300 mW) infrared AlGaAs laser diode operating at 808 nm. The 808 nm light pumps a crystal of neodymium-doped yttrium aluminum vanadate (Nd:YVO₄) (or Nd:YAG or less common Nd:YLF), which lases deeper in the infrared at 1064 nm. The vanadate crystal is coated on the diode side with a dielectric mirror that reflects at 1064 nm and transmits at 808 nm. The crystal is mounted on a copper block, acting as a heatsink; its 1064 nm output is fed into a crystal of potassium titanyl phosphate (KTP), mounted on a heatsink in the laser cavity resonator. The orientation of the crystals must be matched, as they are both anisotropic and the Nd:YVO₄ outputs polarized light. This unit acts as a frequency doubler, and halves the wavelength to the desired 532 nm. The resonant cavity is terminated by a dielectric mirror that reflects at 1064 nm and transmits at 532 nm. An infrared filter behind the mirror removes IR radiation from the output beam, and the assembly ends in a collimator lens.

Nd:YVO₄ is replacing Nd:YAG and Nd:YLF due to lower dependency on the exact parameters of the pump diode (therefore allowing for higher tolerances), wider absorption band, lower lasing threshold, higher slope efficiency, linear polarization of output light, and single mode output.^[5] For frequency doubling of higher power lasers, LBO is used instead of KTP. Newer lasers use a composite Nd:YVO₄/KTP crystal instead of two discrete ones.