Another special offer from our vast stock of motors, this exceptionally powerful for size, reversible ferrite magnet DC motor is not to be missed ! The fully enclosed steel body measures 76mm dia x 105mm long, with a 1/4" dia x 21mm long output shaft. A steel toothed belt drive pulley, 28mm long x 14.6mm dia over the 19 teeth which are approx 1mm wide x 0.9mm high with a 1.4mm spacing which will accept a standard toothed belt. The pulley is easily removable with heat application & leverage.

Unit supplied with a clamped on foot mounting flange with 4 x 3.8mm dia holes on approx 41 x 83mm rectangle. There are an additional 3 equispaced 2BA tapped holes on the drive end face on approx 64mm PCD for mounting. Flying lead connections 250mm long.

When used as a drive motor, typical no load speeds and ratings are as follows:-

Click here for simple DC motor reversing info

*Motor should not be stalled for long periods of time - overheating and damage will result.

Although the motor is designed for 12 to 15 Volt use, Increased Voltages upto 24 Volts may be applied to produce higher RPM & torque. If running on Voltages above 12 Volts, consideration, as with any motor, to excessive heating and bearing wear should be considered.

Motor may also be used as a generator, test loads produced the following:-

Many applications include Robotics, Models,
CNC Machines, Wind Generators, Small Carts etc.

Supplied Brand New with 90 day RTB guarantee.

Buy with confidence from a UK Company established for over 30 years.

All pictures © www.distel.co.uk 2004